Panel Paradise 10 Button Topside Control 52797 52797-Q

Panel: Paradise 10 Button Topside Control Panel for QCA Spas. Includes the 10 button overlay and cord with jack.

Disclaimer: Spa service should only be performed by qualified persons. Working on a hot tub can be dangerous between the electricity, moving parts of the pump and shock hazard.  If you are not 100% comfortable and qualified to work on a spa, contact us for a referral to a service tech in your area.

Control Panel Replacement
This control panel can be exchanged by first turning off the hot tub at the breaker to be sure there is no power going to the spa to avoid injury.  Thencontrol box lid is unscrewed giving access to the circuit board. Care is taken to note where the control panel is plugged into so the new one can be plugged into the same jack. Unplug the phone jack plug and cord on the circuit board that goes to the bad control panel.  Remove the cord/wire from the spa pack and remove the existing control panel.  Service person should be careful not to scratch the acrylic surface with whatever tool is being used to wedge out the old control panel.  Control panels are usually not screwed in but just mounted with double-sided sticky tape.  A new taped gasket is included with the new replacement control panel for easy mounting of the new panel. 

Insert the new replacement control panel into the hole in the spa shell after having removed the old one.  Then thread the wire back into the spa pack and plug into the designated jack on the circuit board.
That is what the repair looks like and it should take about 5-10 minutes. 

Be careful not to scratch the spa shell.  Be sure to turn power off before working on the spa for your safety.

Test new panel when installation is complete and enjoy your hot tub.